Below is a shower remodel. I enlarged the shower, moved plumbing to opposite wall, fabricated pony wall, set a combination of glass, stone and porcelain tile and fabricated Maple vanity cabinet. The client finished up...
Brick curb with pre-pitch
Crown molding
Lots of Listello work
New plumbing and valves
Niche inside pony wall
Maple Cabinet
Below is an adjustable pin shelf bookcase fabricated using Maple plywood for the sides, back and shelving, solid Maple on the face frames; shelving face. The crown is also solid Maple...
30" x 80"
Furniture Look Bottom
Stain & 3 Coats Polyurathane
Below is an in wall speaker wire and installation project. I v-notched the drywall and floated the speaker wire in the wall. The framing was originally set up for plaster walls so this way was much easier than trying to pull wire from above.
In wall Speaker Wire
Set Up
V-Notch Drywall
Floated & Ready for Texture
Below are 2 custom built-in bookcases I fabricated and installed. They have crown molding, adjustable pin shelving, 2 coats Kilz primer and 2 coats Benjamin Moore Satin Impervo applied with my new HVLP turbine sprayer...
Fabrication
Ready for Primer
Finish Painted
Ready for Delivery
Installed
Built-In & Trimmed Out
Below is a complete kitchen update. with new granite, tile backsplash, fabricated 3 glass cabinet doors, tile floor, new appliances; painted cabinets with Fuji HVLP Turbine fine finish system http://www.youtube.com/watch?v=dLOZcagrOpI
Complete story & pictures of this kitchen update including tear out, granite installation and challenges coming soon...
Before
After
After
Demo
New Drywall & Set Up
Set Tile Backsplash
Below is a bathroom cabinet that will hang above toilet. I made a jig for my router to hold down the wood stock in precise position. The cabinet box is fabricated using oak plywood and solid oak face frames with shop made oak pencil bead trim around the interior of face frames adding an interesting detail.
During fabrication the door changed from a glass front to solid wood...
The Jig
Routing the Rail
Rail and Stile Doors
Cabinet Box & Face
Bead Trim Detail
Clamped Rail & Stile Door
Applied Stain
Shelf Pins & Supports
3 Coats Oil Varnish
Below are 3 windows (35" x 71") removed and replaced with Pella Thermastar Windows. The challenge was removing the old window frames without damaging the small exterior bricks in the middle. I also primed and painted metal header (above window)
Before
After
Below is a water damaged soffit and fascia project. Originally I bid on replacing the soffit with the same materials but gave the option of a stained ceiling to tie in with the stained entry door. I found damaged framing inside along with old recessed lights. The framing was repaired and new 4" recessed lights installed. I painted the light trim covers black to go along with all the iron work...
Water Damaged Soffit
Damaged Fascia Board
New Framing and Nail Supports
1 x 4 x 8 Ceiling Bead
New Recessed &Trim Detail
Brushed & Wiped Stain
Polyurathane & Black Light Trim
Repaired & Painted Fascia Board
Below is a built in microwave. I removed the old trim and small microwave, remodeled finished opening to accommodate new trim kit and installed. I'll prime and paint soon...
Old Microwave
Removed Face Frame
Installed New Face
Bulit in Microwave
Below I repaired several drywall cracks, installed crown molding, painted ceiling, primed and 2 coats finish paint on walls
